This project is read-only.

using Mergeoutput

Dec 19, 2014 at 9:37 PM
The usage wasn't to informative about how to use the Mergeoutput, could you provide an example of how to use it?
I know it's -mergeouput but then you have the option of filters but what isn't clear is do I need to point this at the old output somehow. If not what is required to get it to pick up the previous run output.

Dec 20, 2014 at 2:30 AM
just use the same name for the output file name, if it exists it will get loaded and then used as the basis of the new coverage run